MULTIQUIP GAW180HE Operation And Parts Manual page 11

„ NEVER use fuel as a cleaning agent.
„ DO NOT smoke around or near the
equipment. Fire or explosion could result
from fuel vapors or if fuel is spilled on a
hot engine
ELECTRICAL SAFETY
DANGER
„ Turn welder-generator and all circuit breakers OFF
before performing maintenance on the generator or
making contact with output receptacles.
„ NEVER insert any objects into the
output receptacles during operation.
This is extremely dangerous. The
possibility exists of electrical shock,
electrocution or death.
„ Backfeed to a utility system can cause
electrocution and/or property damage.
NEVER connect the welder-generator
to a building's electrical system without
a transfer switch or other approved
device. All installations should be
performed by a licensed electrician in accordance with
all applicable laws and electrical codes. Failure to do so
could result in electrical shock or burn, causing serious
injury or even death.
Power Cord/Cable Safety
DANGER
„ NEVER let power cords or cables lay in water.
„ NEVER stand in water while AC or DC power from the
generator is being transferred to a load.
„ NEVER use damaged or worn cables or cords when
connecting equipment to generator. Inspect for cuts in
the insulation.
„ NEVER grab or touch a live power
cord or cable with wet hands. The
possibility exists of electrical shock,
electrocution or death.
„ Make sure power cables are securely connected to the
generator's output receptacles. Incorrect connections
may cause electrical shock and damage to the generator.
GAW180HE/HEA WELDER-GENSET • OPERATION AND PARTS MANUAL — REV. #1 (10/01/19) — PAGE 11
SAFETY INFORMATION
NOTICE
„ ALWAYS make certain that proper power or extension
cord has been selected for the job. See Cable Selection
Chart in this manual.
Grounding Safety
DANGER
„ These welder-generators are equipped with a grounding
terminal at the base of the pipe frame. Electrical
grounding requirements can differ by State, Province,
District, Municipality, and unique application settings.
„ For portable and vehicle-mounted welder-generators,
Multiquip recognizes the guidance provided in NEC
Handbook Article 250.34 Parts A and B, and 29 CFR
1926.404 (f) (3) (i). If a more defi nitive earth-to-ground
safeguard is required, please consult a qualified
electrician and reference appropriate National Electrical
Code (NEC) guidelines in establishing an exterior
grounding point
„ NEVER use gas piping as an electrical ground.
BATTERY SAFETY
DANGER
„ DO NOT drop the battery. There is a possibility that the
battery will explode.
„ DO NOT expose the battery to open fl ames,
sparks, cigarettes, etc. The battery contains
combustible gases and liquids. If these
gases and liquids come into contact with a
fl ame or spark, an explosion could occur.
„ DO NOT charge battery if frozen. Battery can explode.
When frozen, warm the battery to at least 61°F (16°C)
WARNING
„ ALWAYS wear safety glasses when
handling the battery to avoid eye irritation.
The battery contains acids that can cause
injury to the eyes and skin.
„ Use well-insulated gloves when picking up the battery.
„ ALWAYS keep the battery charged. If the battery is not
charged, combustible gas will build up.