Intermittent Pilot Lighting Instructions - Empire Comfort Systems MILLIVOLT 3 Series Installation Instructions And Owner's Manual

INTERmITTENT PILOT LIGHTING INSTRUCTIONS

FOR YOUR SAFETY REAd BEFORE LIGHTING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A. This appliance has a pilot which can be lit with the wall
or on/off switch, a remote control, or by switching the
remote receiver switch to the "ON" position. When
lighting the pilot, follow these instructions exactly.
B. Before lighting smell all around the appliance area for
gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
What To do If You Smell Gas
• Do not try to light any appliance.
• Do not touch any electrical switch;
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
f i r e - p a r t s . c o m
1. STOP! Read the safety information above.
2. Set wall switch or remote to "OFF."
3. Turn off all electric power to the appliance. (If applicable).
4. Open bottom louver assembly, or open valve access door.
5. Turn gas shut-off valve counterclockwise
position.
6. Wait ten minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow
in the safety information above on this page. If you do not
smell gas, go to the next step.
7. Turn ON electric power to the appliance.
8. Find pilot - Follow metal tube from gas control. The pilot is
behind the burner on the right side.
9. Turn main flame to on. If the pilot does not light within 60
seconds, stop and go to Step 5.
1. Set REMOTE/OFF/ON switch to OFF.
2. Turn off all electric power to the appliance if service is to be
performed (if applicable).
3. Turn gas shut off valve to
38142-2-0719
LIGHTING INSTRUCTIONS
to
TO TURN OFF GAS TO FIREPLACE
"OFF" position.
WARNING
• If you cannot reach your gas supplier, call the fire
department.
C. Use only the remote control or wall switch to operate
the gas valve. Never use tools. If valve does not
operate, don't try to repair it, call a qualified service
technician. Force or attempted repair may result in a
fire or explosion.
d. do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
10. Refer to remote control instructions for detailed information,
control features, and operation. NOTICE: There is a CPI/
IPI switch behind the right side panel that allows for a
continuous standing pilot mode or an intermittent pilot
"On" mode. See appliance manual for location of this switch.
If the pilot or burner does not stay lit (in the standing
pilot mode), stop and immediately call a qualified service
"B" technician or gas supplier.
11. If the burner or pilot does not operate properly after several
tries, turn the gas shut-off valve clockwise
"OFF" and call your service technician or gas supplier.
12. Replace the front surround assembly or close bottom louver
assembly (if applicable).
13. Operation of the gas valve is controlled by a manual on/
off switch or a hand held remote control. Refer to remote
instructions for detailed operation information.
GAS SHUT-OFF VALVE
to
Page 25