Table of Contents
Advertisement
2.3.4
Markings on components
2.3.5
Compatible components
Pipes
2.3.6
Operating mode
2.3.7
Technical data
Easytop circulation regulation valve, static regulation valve with SC-Contur
The press connections are marked with a coloured dot. This identifies
the SC-Contur, where the test medium would escape in the case of an
inadvertently unpressed connection.
The model is marked as follows:
flow direction indicator
n
dimension
n
DVGW writing
n
setting scale
n
green dot for potable water
n
The model is equipped with press connections and compatible with the
Profipress, Sanpress and Sanpress Inox system.
The press connections are tested and approved according to the appli‐
cable regulations with the following pipe types:
Copper pipes
n
–
see
Ä „Regulations from section: Compatible components"
on page 7
Stainless steel pipes (material 1.4401 / 1.4521)
n
–
see
Ä „Regulations from section: Compatible components"
on page 7
The static Easytop circulation regulation valve is used in circulation
pipes and allows hydraulic line calibration. The calibration takes place
via a reproducible presetting.
Observe the following operating conditions for the installation of the
model:
Operating temperature [T
Operating pressure [P
max
Setting range
]
max
]
1.0 MPa (10 bar)
Product information
90 °C
0 - 6.9
11 from 25
Advertisement
Table of Contents
