Hyundai Palisade 2020 Owner's Manual page 132

Hide thumbs Also See for Palisade 2020:

Table of Contents

Convenient features of your vehicle

1. When programming the buttons for

the first time, press and hold the

left and center buttons (

simultaneously for approximately

20 seconds until the indicator light

begins to flash. (This procedure

erases the factory-set default

codes. Do not perform this step to

transmitters.)

For non rolling code garage door

openers, follow steps 2 - 3.

For rolling code garage door

openers, follow steps 2 - 6.

Programming section.

For help with determining whether

your garage is non-rolling code or

rolling code, please refer to the

garage door openers owner's

manual or contact HomeLink cus-

tomer service at 1-800-355-3515.

Programming,

2. Press and hold the button on the

HomeLink system you wish to train

and the button on the transmitter

while the transmitter is approxi-

mately 1 to 3 inches away from the

mirror. Do not release the buttons

until step 3 has been completed.

3. The HomeLink indicator light will

flash, first slowly and then rapidly.

When the indicator light flashes

rapidly, both buttons may be

released. (The rapid flashing light

indicates successful programming

of the new frequency signal.)

Chapters

Table of Contents