Electrical Connection Flap/E-Box [Figure 3-4] - VS 910 Series Operating Instructions Manual

1
(2)
2
(2)
7.5 Table spacers [Figure 1-2]
Position the table spacers for the side (1) and front (2) linking of tables
in such a way that the table feet engage with the corresponding recess.
The anti-rotation protection (3) of the distance piece must hook into
the corresponding opening on the lower side of the table foot.
If both types of table spacer are used at one and the same table foot
then the side spacer is located above the front spacer.
Caution! Table spacers ensure that the necessary safety distance
of 25 mm is observed.
7.6 Electrical connection flap/E-box [Figure 3-4]
The socket block (4) in the electrical connection flap/E-box (5) can be
released by pulling it out of the housing (6) in order to perform the
cabling of the table. To insert, press on the block until it audibly engages
in the holder.
(1)
(1)
(2)
(1)
3
4
(6)
(5)
(4)
(6)
57