Container And Shelf Stop; Troubleshooting; The Table Does Not Move - VS 910 Series Operating Instructions Manual

4.6 Container and shelf stop

Up/down with memory and up/down with memory and display
These two functions can be used in order to limit the travel range
of the desk (for example, if there is a container under the desk).
A container stop position can be set in the lower half of the travel
range and a shelf stop position in the top half. If a container stop
position is set then this acts as a new lower stop position. A shelf
stop position corresponds to a new upper stop position for the travel
range. Proceed as follows to save a container/shelf stop position:
- Move the desk to a position you want by pressing up or down.
- To set a container stop position, hold the Bluetooth® button down
for 8 seconds and simultaneously press the handswitch downwards.
- To set a shelf stop position, hold the Bluetooth® button down for
8 seconds and simultaneously press the handswitch upwards.
- The LED flashes white twice to confirm.
- To delete these stop positions, press and hold down the star and bell
buttons for 8 seconds.

5. Troubleshooting

5.1 The table does not move

- heck whether the maximum operating time has been exceeded (see
section 8) and the operating time restriction has been activated.
- Check whether all the cables are inserted correctly (and if necessary
whether there is a functioning electricity supply)
- Make sure that the load (see section 8) on the table is not too high.
- Make sure that no obstacles are blocking the travel path.
48