Error Codes; Troubleshooting - Customer / Vs Customer Service - VS 910 Series Operating Instructions Manual

5.3 Error codes

An error number is shown at the display
Error code Meaning
E-01 Loss of position Perform a reset
E-16 Button error
E-59 Collision
protection
Channel 1
E-60 Collision
protection
Channel 2
Caution! During the warranty period, the drive elements may only
be replaced by the VS Customer Service (VS-KD).
Important! If you have any further questions, please consult your
responsible expert VS consultant or the appropriate VS branch.
5.4 Troubleshooting – customer / VS Customer Service
Caution! The replacement of the drive technology is only permitted
through the VS customer service (VS-KD)!
When contacting the VS customer service, please use the model no. and the
serial no. of the table. This can be found on a rating plate on the underside
of the tabletop [Figure 4].
4
model no.
50
Remedy/description
Wrong button combination pressed on
handswitch, button combination not
supported
The table's collision protection
has been triggered, Check the travel path
Remove obstacles
The table's collision protection
has been triggered, Check the travel path
Remove obstacles
serial no.