Cable Trays - VS 910 Series Operating Instructions Manual

1
(5)
(1)

7.2 Cable trays

The metal cable tray [Figure 1] must be unlocked before it can be
folded down. To do this, reach through the cut-outs (1) and push the
two locking bars (2) of the left and right sides inwards at the same time.
To close again, move the folded down side of the metal cable tray up-
wards again and ensure that it audibly engages in the locking mechanism.
The textile cable tray [Figure 2] can be folded down on either side. To
open, pull one of the tray's retaining rods (3) outwards out of the clip
connection (4). The textile tray is closed again by clipping in the retaining
rod.
Caution!
Use the strain relief mechanisms for the cable trays.
The strain relief mechanisms (5) in the metal cable trays can be
positioned on the edge or on the inside. In the case of textile cable trays,
the strain relief mechanism (6) is located at the reinforcing clip.
54
2
(2)
(6)
(4)
(3)
(4)
(3)