Epson S5U13U11 User Manual page 11

S1D13U11 Display Controller
JP10 - Touch Screen Power Select
JP10 can be used to select the power of the touch screen.
When the jumper is at position 1-3, the power of touch screen signals (X+, Y+) is selected 3.3V.
When the jumper is at position 1-2, the power of touch screen signals (X+, Y+) is selected 5V.
JP12 - LED Backlight 12V Power Control
JP12 can be used to control the LED backlight 12V power.
When the jumper is at position 1-2, the 12V power is always on.
When no jumper is installed, the 12V power is always off.
JP13 - Ortustech Panel Power Control
JP13 can be used to control Ortustech panel power (S5U13U11P10C100 only).
When the jumper is at position 1-2, the GPO7 pin of the S1D13U11 can be used to control the Ortustech panel
power.
When the jumper is at position 2-3, the Ortustech panel power is always on.
Figure 3-4: Configuration Jumper Locations (JP10, JP12, JP13)
S5U13U11 Evaluation Board User Manual (Rev. 1.1) EPSON 11