Table of Contents
Advertisement
PRODIGIT
Chapter 2 Installation
2-1 Inspection
The 3260A Series High Power Electronic Load was carefully inspected before shipment. If
instrument damage has occurred during transport, please inform Prodigit's sales and service
office or representative.
Your 3260A Series High Power Electronic Load was shipped with a power cord for the type
of outlet used at your location. If the appropriated cord was not included, please contact your
nearest Prodigit sales office to obtain the correct cord. Refer to " check line voltage " to check
the line voltage selection and fuse type.
2-2 Check line voltage
The 3260A Series High Power Electronic Load can operation with 115, 230Vac input as
indicated on the label on the rear panel.
Make sure that the factory check mark correspond to your nominal line voltage. Skip this
procedure if the label is corrected marked.
2.2.1
With the 3260A Series High Power Electronic Load power OFF, disconnect the
power cord.
2.2.2
Refer the drawing on the rear panel in Fig 2-1, set the switches to the proper voltage
as describe in the following:
2.2.3
Mark the correct voltage on the rear panel of 3260A Series High Power Electronic
Load.
2.2.4
Check the rating of the line fuse and replace it with the correct fuse if necessary.
2.2.5
The line fuse is located below the AC line receptacle see Fig 2-2. With the power
cord removed, use a small screwdriver to extract the fuse holder from under the AC
socket. Replace the fuse with the appropriate type as indicated in Table 1-1. These
fuses are normal-blow fuses.
SYNC INPUT
RANGE
1
1
5
Fig.2-1 SET OF SWITCH
3260A Series Operation Manual 9
Hide quick links:
Advertisement
Table of Contents
