Fig.3-5 Test Mode Operation Flow-Chart - Prodigit 3260A Series Operation Manual

PRODIGIT
Yes
Press Exit key
PASS
4.2
Show GO
S3+S4
Show n1-n9 Initial = n1
1
Start Mode
Testing
Show Memery
2
bank and State
3
Sp = Sp+1
EXI
No
4.1
4
No
End?
Yes
FAI
L
PASS/FAIL
4.3
Show NG
Any key

Fig.3-5 TEST MODE OPERATION FLOW-CHART

1.Press S3+S4 key, and S3 and S4 LED are ON
2.Show AUTO SEQ. No.1-No.9,
Press Up/Down key to set n1-n9
3.Press Start key to Start Mode
Press Start key
1.To recall correspond memory which had been stored in n1-n9 memory
2.Check the GO/NG indicator
3.Press Exit key to quit the AUTU SEQ mode
4.If test is GO, than step is last?
4.1 If no than Step + 1, continue another step.
4.2 If "Yes", than if all the test in all module is pass,
Show GO.
4.3 If "Yes", than if there is at least one failure during the test,
Show NG.
3260A Series Operation Manual 23