Table of Contents
Advertisement
Chapter 2 Installation
2-1. Inspection
The 33501 Series high power load was carefully inspected before shipment. If instrument
damage has occurred during transport, please inform Prodigit's sales and service office or
representative.
Your 33501 Series high power load was shipped with a power cord for the type of outlet used
at your location. If the appropriated cord was not included, please contact your nearest
Prodigit sales office to obtain the correct cord. Refer to "check line voltage "to check the line
voltage selection and fuse type.
2-2. Check line voltage
The 33501 Series high power load can operation with 115, 230Vac input as indicated on the
label on the rear panel.
Make sure that the factory check mark corresponds to your nominal line voltage. Skip this
procedure if the label is corrected marked.
2-2-1
With the 33501 Series load power OFF, disconnect the power cord.
2-2-2
Refer the drawing on the rear panel of 33501 Series high power load in Fig 2-1, set
the switches to the proper voltage as describe in the following:
Voltage configuration
2-2-3
Mark the correct voltage on the rear panel of 33501 Series high power load.
2-2-4
Check the rating of the line fuse and replace it with the correct fuse if necessary.
2-2-5
The line fuse is located below the AC line receptacle see Fig 2-2. With the power
cord removed, use a small screwdriver to extract the fuse holder from under the AC
socket. Replace the fuse with the appropriate type as indicated in Table 1-2. These
fuses are normal-blow fuses.
2-2-6
Reinstall fuse holder and connect the power cord.
Voltage selection switch
Fig 2-1 SET OF SWITCH
Fig 2-2 AC LINE RECEPTACLE
33501 Series Operation Manual 2-1
Advertisement
Table of Contents
