Safety - Ergotron StyleView User Manual

Hazard Symbols
Review
These symbols alert users of a safety condi-
tion that demands attention. All users should
be able to recognize and understand the
signifi cance of the following Safety Hazards
if encountered on the product or within the
documentation. Children who are not able to
recognize and respond appropriately to Safety
Alerts should not use this product without
adult supervision!

Safety

CAUTION: Close worksurface before
opening drawers. Open only one
drawer at a time. Do Not push
cart when drawers or worksurface
are open. Failure to follow these
instructions may cause the cart to be
unstable.
2 of 18
Signal Word/
Symbol
Color
DANGER
WARNING
CAUTION
CAUTION
INSTRUCTIONS
INSTRUCTIONS
POWER
WARNING
14mm (9/16")
IMPACT HAZARD!
MOVING PARTS CAN CRUSH AND CUT.
Minimize Lift Tension BEFORE:
· Removing Mounted Equipment.
· Shipping Cart
· Storing Cart
To Minimize Lift Tension
1. Lower worksurface to lowest position.
2. Turn adjustment nut at top of riser
counterclockwise until it stops
(Adjustment may require 40-60 revolutions).
Failure to heed this warning may result in
serious personal injury or property damage!
For More information and instructions refer to product
guide at http://4support.ergotron.com or contact
Ergotron Customer Care at 1-800-888-8458.
822-052
Level of Hazard
Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
Used without the safety alert symbol indicates a potentially
hazardous situation which, if not avoided, may result in
property damage.
Follow operating instructions.
Follow operating instructions.
"ON" / "OFF" (push-push)
NOTE: Each position "ON" / "OFF" is a stable position.
Important! You will need to adjust this product after installation
is complete. Make sure all your equipment is properly installed
on the product before attempting adjustments. This product
should move smoothly and easily through the full range of
motion and stay where you set it. If movements are too easy
or diffi cult or if product does not stay in desired positions,
follow the adjustment instructions to create smooth and easy
movements. Depending on your product and the adjustment,
it may take many turns to notice a diff erence. Any time
equipment is added or removed from this product, resulting in
a change in the weight of the mounted load, you should repeat
these adjustment steps to ensure safe and optimum operation.
888-97-333-G-00 rev. A • 09/13