Honeywell Centraline LION Installation & Commissioning Instructions page 5

LION System
I/O Module Overview
Panel Bus L W
ON ORKS
module Bus module
CLIOP821A CLIOL821A
CLIOP822A CLIOL822A
CLIOPR822A CLIOLR822A
CLIOP823A CLIOL823A
CLIOP824A CLIOL824A
CLIOPR824A CLIOLR824A
CLIOPR825A –
CLIOP830A --
CLIOP831A --
1)
In addition to the power LED and service LED
2)
Changeover outputs
Table 3 Overview of I/O modules
Manual Overrides as per EN ISO 16484-2:2004
The manual override switches and potentiometers of the output modules (...R822A, ...R824A, and CLIOPR825A) support direct
operation as per EN ISO 16484-2:2004, section 5.4.3 "Local Priority Override/Indicating Units."
Specifically, the positions of the manual override switches and potentiometers directly control the outputs – independently of the
LION Controller and HMI. When a manual override switch or potentiometer is not in its default position ("auto"), the cor-
responding output LED will blink continuously, and the output module will send a feedback signal with the status "manual
override" and the given override position to the LION Controller (which will then also store this information in its alarm memory).
NOTE: When updating the firmware of output modules, their outputs are turned OFF – regardless of the position of their
manual override switches and/or potentiometers.
Corresponding Terminal Sockets
I/O module
Socket
CLIOP/CLIOL...
...821
XS821-22
XSU821-22
...822
XS823
...823
XSU823
...824
XS824-25
XSU824-25
...825
Table 4 Pluggable I/O modules and corresponding
terminal sockets
Description Inputs Outputs
Analog input module
Analog output module
Analog output module
Binary input module
Relay output module
Relay output module
Floating output module
Mixed I/O module
Mixed I/O module
Scope of delivery
1 terminal socket,
1 bridge connector
1 swivel label holder
1 terminal socket,
1 bridge connector
1 swivel label holder
1 terminal socket,
1 bridge connector
1 swivel label holder
1 cross connector
5
Manual controls
8 – –
– 8 –
– 8 8 Manual overrides 8 status LEDs
12 – –
2)
– 6 –
2)
– 6 6 Manual overrides 6 status LEDs
– 3 3 Manual overrides 3 pairs of status LEDs
20 14 --
20 14 --
NOTE: In the following, e.g., ...822 is used to summarize
all analog output modules (Panel Bus/L
Bus, with/without manual overrides).
System Overview
1)
LEDs
–
8 status LEDs
12 status LEDs
6 status LEDs
18 status LEDs
18 status LEDs
W
ON ORKS
EN1Z-0921GE51 R0315