Setting The Units - A&D UC-352BLE-V Instruction Manual

• Turn the power of other Bluetooth
• If measurement data cannot be received, try pairing again.
• After pairing is complete, all communications are done automatically if the receiver is in the receivable state.
• In the unlikely event that this scale causes radio wave interference to another wireless station, either change the
location where the scale is used or stop using the scale immediately.

Setting the Units

1. Confirm that the scale is turned off, and press the
set switch.
2. Press the set switch to select the unit that you want
to set.
• The unit changes each time the set switch is
pressed.
• Wait for 3 seconds after setting the unit.
3. Confirm that "End" is displayed.
• The settings are saved.
• After three seconds of non-operation, the scale
confirms the selected unit with two beeps,
displays "End " and automatically turns off.
4. If you to wish to delete any readings stored in
memory press the set switch. Changing the units
format will delete any stored readings on the scale.
Nota: to see readings stored in memory they must be transferred
to your mobile device and displayed in the reciever's application.
Cautions for Pairing
devices off when performing pairing.
®
E-8
Beep
lb
lb
kg
Beep beep