Res-Up® Feeder Installation Instructions - NOVO EFC20 Owner's Manual

RES-UP FEEDER INSTALLATION
®
INSTRUCTIONS (OPTIONAL)
Res Up Feeders or Res Care Feeders attach to your brine tank and automatically dispense the Resin cleaner into the brine solution where it
cleans the resin during the regeneration cycle.
The feeder hooks onto the tube inside your brine tank and you just pour some chemical in. A res-up feeder or res-care Feeder is essential
if your raw water contains measurable amounts of iron.
The 12 cc feeder (Part # 33010) is for softeners up to 64,000 grains (2 ft3 of resin).
Installation of Res Up Feeder in Round Brine Tank (Optional)
1. Install the grid and brine well inside the round tank.
4. IInstall the holder and the Res Care Solution
22
Res-up Feeder Bottle (Chemical sold Separately)
The 30 cc feeder (Part # 33018) is for larger softeners over 64,000 grains.
55030007 1/2 oz rescare starter kit
55030008 1 oz rescare starter kit
80030022 Pro Rescare 64 oz
Pro-Res Care Chemicals
Item #45147 Pro-ResCare - Gallon
Item #45148 Pro-ResCare - Quart
2. Measure 2 inches from the top of the tank beside
the oblong molding.
3. Mark the location of the holder and drill.
Res Care kit
5. Take off the small hole cover on the Brine
Well lid.
6. Take off the cover of the Res Care bottle . Insert the
wick, making sure it touches the bottom of the
bottle. Insert the other end of the tube completely
into the hole in the brine well cap. Automatic
feeding will start in a few hours.
Res-up feeder
5/8" hole in brine
well cap
1/4" Holes