Installing Brine Tank - NOVO EFC20 Owner's Manual

INSTALLING BRINE TANK

Assembling Brine Tank*
a) Attach the three brine grid legs to grid plate. The legs
will snap on to the tabs of the salt plate making a "click"
sound. For square brine tank there are four legs.)
b) Insert the brine well assembly inside the grid
plate as well below.
14
c) Drop the brine grid with brine well inside the
brine tank such that the nut fitting faces the
hole on the brine tank. Then press the grid
evenly inside the brine tank until the brine grid
legs touches the bottom of the brine tank.
IMPORTANT:
IT IS IMPORTANT
TO ALIGN THE
HANDLE TO THE
BRINE WELL AS
SHOWN
The hole in
the brine tank
should line up
with the brine
line as shown
Attaching Brine Tubing to the Brine Line of the Valve
Be sure to remove blue clip before inserting tubing so that the
tubing does not get damaged by the grip ring. Once tubing is
fully inserted replace the blue secure clip
d) Take the brine tube and insert the nut and plastic sleeve as
shown below.
Insert Sleeve
e) Insert the tube in the float assembly elbow and hand tighten
the nut. In many cases the brine line already come installed
from the factory. Leave the other end of the brine line tube
inside the brine tank
f) For installation of brine tank at the installation site, pull the
other end of the brine tube from the hole on the brine tank.
The completed assembly is shown below.
*
NOTE
Resin Cleaner
An approved resin cleaner
MUST be used on a regular
basis if your water supply
contains iron.
See page 22 - Res-Up®
Feeder Installation
Instructions