Read This Page First; Before Starting Installation - NOVO EFC20 Owner's Manual

READ THIS PAGE FIRST

BEFORE STARTING INSTALLATION


Read this manual thoroughly to become familiar with the
device and its capabilities before installing or operating your
Water Filter. Failure to follow instructions in this manual
could result in personal injury or property damage. This
manual will also help you to get the most out of your filter.

This system is intended for use on municipal water only and
its installation must comply with all State, provincial or local
regulations. Check with your local public works department
for plumbing and sanitation codes. In the event the codes
conflict with any content in this manual the local codes
should be followed. Consult your licensed plumber for
installation of this system.

This water filter is designed to operate on pressures of 30 psi
to 125 psi. If the water pressure is higher than the maximum
use a pressure reducing valve in the water supply line to the
filter.

This unit is capable of operating at temperatures between
40°F and 110°F (4°C - 43°C). Do not use this water filter on hot
water supplies.

Do not install this unit where it may be exposed to wet
weather, direct sunlight, or temperatures outside of the
range specified above.
INSTALL NOTES &
SAFETY MESSAGES
Watch for the following
messages in this manual:

Avoid pinched o-rings during installation by applying
(provided with install kit) NSF certified lubricant to all seals.

Filters are commonly exposed to high levels of iron,
manganese, sulfur, and sediments. Damage to pistons, seals,
and or spacers within the control valve are not covered in
this warranty due to the harsh environment.

It is recommended to regularly inspect and service the
control valve on an annual basis. Cleaning and or replacement
of piston, seals, and or spacers may be necessary depending
on how harsh the conditions are.

Do not use water that is microbiologically unsafe without
adequate disinfection before or after this system.

This publication is based on information available when
approved for printing. Continuing design refinement could
cause changes that may not be included in this publication.
The manufacturer reserves the right to change the
specifications referred to in this literature at any time,
without prior notice.
NOTE
Do not remove or destroy
the serial number. It must be
referenced on request
for warranty repair or
replacement
CAUTION!

Disassembly while
under pressure can
result in flooding.
WARNING!
ELECTRICAL SHOCK
HAZARD! UNPLUG THE UNIT
BEFORE REMOVING THE
COVER OR ACCESSING ANY
INTERNAL CONTROL PARTS
NOTE:
used to emphasize
installation, operation or
maintenance information

which is important but does
not present a hazard.
CAUTION:
used when
failure to follow directions

could result in damage to
equipment or property.
3
WARNING:
used to
indicate a hazard which

could cause injury or death if
ignored.