Installation - NOVO EFC20 Owner's Manual

INSTALLATION

Connect Softener to the HousePlumbing Any solder joints near the valve must be done before connecting any piping to the valve. Always leave at least 6" (152 mm)
between the valve and joints when soldering pipes that are connected to the valve. Failure to do this could cause damage to the valve.
EconoFlo Water Softener Installation
To Outside Faucet
Cold (Soft Water)
Hot (Soft Water)
AC 120V/10A
Current Protect Socket
Brine Valve
Connector
Detail
Optional
Overflow
Assembly
Cold (Raw water)
In Out
Out
Water Heater
Water Pipe Inlet
Brine Elbow
Assembly
3/8" Brine Tube
Brine Tank
5/8"
Overflow
Line
(Only Optional
required if
Pipes Fixed
overflow
Structure
assembly is
installed.)
NOTE
Waste connections or drain
outlet shall be designed and
constructed to provide for
connection to the sanitary
waste system through an
air-gap of 2 pipe diameters
or 1 inch (22 mm) whichever
is larger.
Cold (Filtered water)
In Out
Water Softener
Water Pipe Outlet
Drain Elbow
Assembly
Pressure Tank
5/8" Drain Line
Floor Drain
CAUTION!
Never insert drain line
directly into a drain, sewer line, or trap.
Always allow an air gap between the drain
line and the wastewater to prevent the
possibility of sewage being back-siphoned
into the conditioner.
Cold (Raw water)
*
Check Valve
In
Water Filter
*NOTE
Check local plumbing codes
in regards to requirements
for use of Check Valve or
back flow prevention or
vacuum breaker
NOTICE - THERE ARE RAISED
ARROWS ON THE BYPASS
ASSEMBLY INDICATING
DIRECTION OF WATER FLOW
Inlet
Outlet
Laundry Drain
15