Startup Instructions - NOVO EFC20 Owner's Manual

STARTUP INSTRUCTIONS

1. Connect the Transformer to the Valve
Plug the 12-volt transformer into a 120 VAC 60 Hz outlet.
3. Add Water to Brine Tank
Open the brine tank /cabinet salt lid and add water as
per the info below. Do not add salt to the brine tank at
this time.
BTR-100 -2.5 US Gallons
4. Manually Regenerate the Valve
Manually index the valve with the control knob to BA.WA. or press SELECT
delay flashing press Up or Down Arrows
regeneration. Once the valve is in the Backwash (BA.WA.) position please unplug.
SERVICE
Sample
Connection
BYPASS
Regen Sequence - Once in Regeneration, the cycle can be skipped by pressing any button.
BACKWASH
IIIIIIIIIIIIIIIIIIIIIIII 15 Minutes*
Key Pad Configuration:
SETTINGS - This function is to enter the basic set up information required at the
time of installation.
SELECT - This function is to accept the values if changed and advance to the next
page in the menu.
UP/DOWN - These buttons are used to increase or decrease the value of the
SERVICE
settings while in the programming mode.
to immediate and press SETTINGS
Sample
Connection
BYPASS
Sample
Connection
BRINE DRAW
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII 50 Minutes*
2. Screen Display
Familiarize with Button Configuration:
TIME
05:22 PM
and hold display will come up showing
to initiate a manual
Sample
Connection
MANUAL REGEN
Delay Immediate
BACKWASH
BRINE DRAW
RINSE (SKIP)
REFILL (SKIP)
*NOTE
Times indicated
here are
example only.
The controller will show the
following on the screen - Time,
Date and Remaining Gallons or
Days.
17