Changing The External Zero Setting - GAGEMAKER MIC TRAC MT-3000 Operation Manual

M I C T R A C M T - 3 0 0 0
M I C T R A C M T - 3 0 0 0

Changing the External Zero Setting

Note: The MIC TRAC CPU ships standard with a preset external zero setting of 1.5000. The 1.5000
reflects the outside dimension of a set of standard flat face anvils or TF-1F blocks. If necessary,
this preset number may be changed by following the steps below. However, when using
standard TF-1F blocks, the preset external zero setting should be reset to 1.5000.
1. To change the external Zero setting,
press the
the 7 and 1 keys.
2. Key in the new external Zero value and
press the
3. The unit must be "re-zeroed" by
pressing the
4. This new external zero setting will
remain the default setting until it is
changed, even if the power is turned off.
20
O p e r a t i o n M a n u a l
O p e r a t i o n M a n u a l
key and then press
key.
key.