Hsdb (Ethernet) Configuration Page; Interfaced Equipment Page; Figure 6-6. Hsdb Port Utilization Page; Figure 6-7. Interfaced Equipment Page - Garmin GTN 635 Installation Manual

GTN Selection
Lightning Detector 1
MapMX
Panel GTX w/TIS #1
Panel GTX w/TIS #2
6.6.3

HSDB (Ethernet) Configuration Page

Access the HSDB Ethernet page, as shown in Figure 6-6,
by touching the ‗HDSB (Ethernet)' key on the GTN Setup
page. Touch the key next to the port to configure it as
‗Connected' or ‗Not Connected'. If a Garmin LRU is
connected to a specific Ethernet port, then configure the
port as ‗Connected'. If no LRU is connected to the port,
configure it as ‗Not Connected.'
6.6.4

Interfaced Equipment Page

Access the Interfaced Equipment page, as shown in
Figure 6-7, by touching the ‗Interfaced Equipment' key
on the GTN Setup page. This page allows the
configuration of the presence of a cross-side navigator,
GDL 69/69A, Transponder #1 and Transponder #2.
GTN 625/635/650 TSO Installation Manual
190-01004-02
GNS Equivalent
Serial communication to an L3 Communications WX-500
WX-500
Stormscope.
Serial position, altitude, velocity, and navigation data.
MapMX
Select this format for the GTX 330/330ES transponder #1. This
N/A provides ground speed, GPS PVT, and pressure altitude
information to the transponder.
Select this format for the GTX 330/330ES transponder #2. This
N/A provides ground speed, GPS PVT, and pressure altitude
information to the transponder.
Description

Figure 6-6. HSDB Port Utilization Page

Figure 6-7. Interfaced Equipment Page

Page 6-9
Rev. C