Configuration Page; Figure 6-5. Rs-232 Configuration Page - Garmin GTN 635 Installation Manual

6.6.2 RS-232 Configuration Page
Access the RS-232 Configuration page, as shown in
Figure 6-5, by touching the ‗RS-232 key' on the GTN
Setup page. Change the inputs or outputs to match the
equipment that is installed in the aircraft. Touch the
key corresponding to the RS-232 channel and select
the applicable input or output setting. The input/output
settings are described below. Touch the ‗UP' or
‗DOWN' key to scroll through the RS-232 selections.
CHANNEL INPUT SELECTIONS
GTN Selection
Off
Airdata Format 1
Altitude Format 1
Altitude Format 3
FADC Format 1
Fuel Format 1
Fuel Format 2
GMA Format 1
GTX Mode C #1
GTX Mode C #2
GTX Mode S #1
GTX Mode S #2
GTX w/TIS #1
GTN 625/635/650 TSO Installation Manual
190-01004-02
GNS Equivalent
Off No unit(s) connected to input of this channel.
Serial air data information from the following units:
Shadin-adc
Shadin ADC 200, 200+, 2000.
Serial altitude data from the following units:
Icarus Instruments 3000
Sandia SAE5-35
Icarus-alt
Garmin GTX 327 Transponder
Trans-Cal Industries IA-RS232-X, SSD120
ACK Technologies A-30 (Mod 8 and above)
Serial altitude data from the following units:
Shadin-alt
Shadin 8800T, 9000T, 9200T
Serial air data and fuel flow information from the following units:
Shadin-fadc Shadin 9628XX-X Fuel/Air Data Computer
INSIGHT TAS 1000 Air Data Computer
Serial fuel flow information from the following units:
Arnav/ei-fuel ARNAV FC-10, FT-10
Electronics International FP-5L
Serial fuel flow information from the following units:
Shadin 91053XM Digital Fuel Management System
Shadin-fuel
Shadin 91204XM Digital Fuel Management System
JP Instruments EDM-700 or EDM-760 Engine Monitor
This input format supports the GMA 35 audio panel interface.
N/A
Select this format for the GTX 32 transponder #1. Provides status
data, altitude data, and flight ID. Choosing this input setting will
N/A
automatically configure the corresponding channel output to the
same setting.
Select this format for the GTX 32 transponder #2. Provides status
data, altitude data, and flight ID. Choosing this input setting will
N/A
automatically configure the corresponding channel output to the
same setting.
Select this format for the GTX 33/33ES transponder #1. Provides
status data, ICAO address, and Flight ID. Choosing this input
N/A
setting will automatically configure the corresponding channel
output to the same setting.
Select this format for the GTX 33/33ES transponder #2. Provides
status data, ICAO address, and Flight ID. Choosing this input
N/A
setting will automatically configure the corresponding channel
output to the same setting.
Select this format for the GTX 33/33ES transponder #1. Provides
status data, TIS data, ICAO address, and Flight ID. Choosing this
N/A
input setting will automatically configure the corresponding
channel output to the same setting.

Figure 6-5. RS-232 Configuration Page

Description
Page 6-7
Rev. C