Garmin GTN 635 Installation Manual page 182

GTN 6XX
4
P1001
ARINC 429 OUT 1A 10
7
ARINC 429 OUT 1B 29
ARINC 429 IN 1A
48
ARINC 429 IN 1B 67
P1004
VOR/ILS ARINC 429 OUT A
24
6
VOR/ILS ARINC 429 OUT B 23
NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. GROUND DESIGNATIONS:
3. AT THE GTN 6XX, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL -- THE SHIELD LEADS MUST BE LESS
THAN 3.0". CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT CHASSIS WITH AS SHORT A CONDUCTOR AS PRACTICAL.
4. FOR GTN 6XX CONFIGURATION SETTINGS, SEE SECTION 6.
5. SEE GARMIN GAD 42 INSTALLATION MANUAL FOR COMPLETE PINOUT AND INTERCONNECT INFORMATION. CONFIGURE
THE ARINC 429 BUS SPEED TO MATCH THE GTN 650 OUTPUT SPEED.
6. THESE CONNECTIONS ARE ONLY USED ON THE GTN 650.
7. IF THE ARINC 429 OUT 1 PORT (P1001 PINS -10 AND -29) IS ALREADY USED FOR ANOTHER PURPOSE, THE ARINC 429
OUT 2 PORT (P1001 PINS -9 AND -28) MAY BE CONNECTED IN LIEU OF PORT 1.
Page D-28
Rev. C
s
s
s
s SHIELD BLOCK GROUND
Figure D-16. GTN 6XX - GAD 42 Interconnect
AIRFRAME GROUND
GTN 625/635/650 TSO Installation Manual
GARMIN GAD 42
5
P421
1 GPS ARINC 429 IN A
2 GPS ARINC 429 IN B
ARINC 429 OUT A
13
14 ARINC 429 OUT B
NAV ARINC 429 IN A
3
4 NAV ARINC 429 IN B
190-01004-02