Eng Page Softkeys (Example Configuration); Lean Assist Mode (Optional) - Garmin G3X Pilot's Manual

ENG PAGE SOFTKEYS (EXAMPLE CONFIGURATION)

NOTE: The Engine (ENG) Page softkeys displayed are dependant on the
configuration. Refer to the G3X Installation Manual for information on
configuring the Engine Page.
If the Engine Page information configured exceeds one page, additional engine
gauges may be distributed among the 1st, 2nd, and 3rd softkeys as required.
(optional)
XXXX
MAIN, TEMPS
AUX, AUX1, AUX2, ELEC,
TRIM, TEMPS
LEAN
FUEL

3.2 LEAN ASSIST MODE (OPTIONAL)

NOTE: The pilot should follow the engine manufacturer's recommended
leaning procedures as described in the Pilot's Operating Handbook (POH).
A LEAN Softkey is displayed on the ENG Page if Lean Assist Mode is enabled and
at least one Exhaust Gas Temperature (EGT) or Turbine Inlet Temperature (TIT) input is
configured (refer to the G3X Installation Manual for more information).
Using Lean Assist Mode:
From the ENG Page, press the LEAN Softkey. As the mixture is leaned, one of
the cylinders' exhaust temperature will peak. Continuing to lean the mixture
will cause each additional cylinder to peak (if applicable) until the last of the
cylinders peaks. To cancel Lean Assist Mode, press the LEAN Softkey again.
190-01115-00 Rev. J
(optional)
XXXX XXXX
Displays engine gauges as required (optional)
Displays additional engine gauges as required
(optional)
Activates/deactivates Lean Assist (optional)
Displays Fuel Calculator (optional)
Garmin G3X Pilot's Guide
(optional) (optional)
LEAN FUEL
EIS
99