Garmin GTN 635 Installation Manual page 168

TYPICAL CONNECTIONS TO ARINC 429 TRAFFIC SOURCE
GTN 6XX
ARINC 429 IN 1
TRAFFIC TEST
TRAFFIC STANDBY
GTN 6XX
4
RS-232 OUT 1
RS-232 IN 1
RS-232 GND 1 46
GTN 6XX
ETHERNET IN 4
ETHERNET OUT 4
NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. GROUND DESIGNATIONS:
3. AT THE GTN 6XX, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL -- THE SHIELD LEADS MUST BE LESS
THAN 3.0". CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT CHASSIS WITH AS SHORT A CONDUCTOR AS PRACTICAL.
4. ONLY ONE TRAFFIC SOURCE MAY BE CONNECTED TO THE GTN 6XX.
5. REFER TO SECTION 6 FOR GTN 6XX CONFIGURATION SETUP.
6. SOFTWARE VERSION 1.6 OR HIGHER REQUIRED FOR THE TRC 497.
7. THESE OPTIONAL DISCRETE CONNECTIONS ARE NOT REQUIRED IF THE GTN 6XX IS CONFIGURED FOR „+ EXTERNAL
CONTROL‟. IN THIS CASE, THE GTN 6XX WILL NOT CONTROL THE TRAFFIC ADVISORY SYSTEM OPERATION. REFER TO
MANUFACTURER‟S DOCUMENTATION FOR COMPLETE PINOUT AND INTERCONNECT INFORMATION.
8. USE AIRCRAFT GRADE CATEGORY 5 ETHERNET CABLE. THIS INCLUDES THE FOLLOWING:
MANUFACTURER
PIC WIRE AND CABLE
ELECTRONIC CABLE SPECIALIST
Page D-14
Rev. C
P1001
4
48
A
B 67
s
75
(OPTIONAL)
76
TYPICAL CONNECTIONS TO TIS SOURCE
P1001
8
27
s
TYPICAL CONNECTIONS TO HSDB SOURCE
4
P1002
A 13
B 14
A 4
B 5
s
s SHIELD BLOCK GROUND
10424 (24 AWG)
392404 (24 AWG)
Figure D-8. GTN 6XX - Traffic Interconnect
TRAFFIC ADVISORY
SYSTEM
A
ARINC 429 OUT
B
TAS TEST IN
7
STANDBY / OPERATE
TIS SOURCE
(TRANSPONDER)
RS-232 IN 1
RS-232 OUT 1
SIGNAL GND
HSDB SOURCE
8
A
ETHERNET OUT
B
A
ETHERNET IN
B
s
AIRFRAME GROUND
P/N
GTN 625/635/650 TSO Installation Manual
190-01004-02