Connect the Module to an EtherNet/IP Network Via a RJ45 Connection
Wire the RJ45 connector as shown.
Connect the Module to the Network
Follow these steps to connect the module to the network.
WARNING: If you connect or disconnect the communication cable with power applied to this module or any device on the network, an
electrical arc can occur. This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
1. Attach the cable with the RJ45 connector to the Ethernet port on the module as shown.
2. Attach the other end of the cable to the devices in your network.
8 ------ NC
7 ------ NC
6 ------ RD-
5 ------ NC
4 ------ NC
3 ------ RD+
2 ------ TD-
1 ------ TD+
RJ 45
32457
Rockwell Automation Publication 1756-IN618A-EN-P - September 2015
8
1
1756 EtherNet/IP Secure Communication Module
7