Rockwell Automation Allen-Bradley 1756-EN2TSC Installation Instructions Manual page 4

1756 EtherNet/IP Secure Communication Module
Prevent Electrostatic Discharge
Table 5 -
ATTENTION:
• This equipment is sensitive to electrostatic discharge, which can cause internal damage and affect normal operation. Follow these guidelines
when you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wrist strap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• Use a static-safe workstation, if available.
• Store the equipment in appropriate static-safe packaging when not in use.
Before You Install the Module
To operate an EtherNet/IP communication module on an EtherNet/IP network, you must assign a network IP address.
Figure 1 - How the IP Address is Set
No
Is DHCP or
BOOTP enabled?
Module uses IP address
that is stored in
nonvolatile memory.
4
Module Powerup
No
Yes
Module requests
address from DHCP/
BOOTP server.
Module has an IP address.
Rockwell Automation Publication 1756-IN618A-EN-P - September 2015
Yes
Switches set
from
001...254?