B Sfp+ Transceiver For Fc/Iscsi Ports - Dell EMC PowerVault ME4 Series Deployment Manual

SFP+ transceiver for FC/iSCSI ports
This section describes how to install the small form-factor pluggable (SFP+) transceivers ordered with the ME4 Series FC/iSCSI
controller module.
Locate the SFP+ transceivers
Locate the SFP+ transceivers that shipped with the controller enclosure, which look similar to the generic SFP+ transceiver that is shown
in the following figure:
Figure 41. Install an SFP+ transceiver into the ME4 Series FC/iSCSI controller module
1. CNC-based controller module face
3. SFP+ transceiver (aligned)
5. SFP+ transceiver (installed)
NOTE: Refer to the label on the SFP+ transceiver to determine whether it supports the FC or iSCSI protocol.
Install an SFP+ transceiver
Perform the following steps to install an SFP+ transceiver:
NOTE: Follow the guidelines provided in
1. Orient the SFP+ transceiver with the port and align it for insertion.
For 2U controller enclosures, the transceiver is installed either right-side up, or upside down depending upon whether it is installed into
controller module A or B,
2. If the SFP+ transceiver has a plug, remove it before installing the transceiver. Retain the plug.
3. Flip the actuator open.
NOTE: The actuator on your SFP+ transceiver may look slightly different than the one shown in
SFP+ transceiver into the ME4 Series FC/iSCSI controller module
4. Slide the SFP+ transceiver into the port until it locks securely into place.
5. Flip the actuator closed.
2. CNC port
4. Fiber-optic cable
Electrical safety when installing an SFP+ transceiver.
Figure 41. Install an
SFP+ transceiver for FC/iSCSI ports
B
83