Exiting Scsi Setup - Siemens SIMATIC RI 45 PIII Series Manual

SCSI Option
7.2.2

Exiting SCSI Setup

When you press the
level is displayed. If you have made changes in the current menu, you will be
asked if you want to save the changes you have made.
7.2.3 SCSI Setup Default Settings
SCSI-Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Additional Options
Boot device Options
Boot Target ID
Boot LUN Number*
SCSI Device Configuration (for each SCSI device)
SCSI Device ID
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
Send Start Unit Command**
Multiple LUN Support**
Include in BIOS Scan
Advanced Configuration Options
Plug and Play SCAM Support
Reset SCSI Bus at IC Initialization
Extended BIOS Translation for DOS Drives >
1 Gbyte**
Host Adapter BIOS
Support Removable Disk Under BIOS as Fixed
Disks**
Display
Initialization**
BIOS Support for Bootable CD-ROM**
BIOS Support for Int 13 Extensions**
* The setting is only effective if Multiple LUN Support is active (Enabled).
** The setting is only effective if the BIOS of the SCSI controller is active
7-6
key, the previous menu from the current menu
ESC
Repeatedly press the
ESC
level (Configure/View Host Adapter Settings).
Press the key in the first menu and follow subsequent screen
ESC
prompts to exit SCSI Setup.
Ctrl A
+ message During BIOS
(Enabled).
key until you have reached the first menu
Default Setting
7
Enabled
LowON/HighON
Default Setting
0
0
1 to 15
Yes
40 Mbyte/s
Yes
Yes
No
No
Yes
Disabled
Enabled
Enabled
Enabled
Boot only
Enabled
Enabled
Enabled
C79000-G7076-C817-01
RI 45 PIII, Manual