Table of Contents
Advertisement
1.3.9
Removing and Installing Module Retainers
First remove the crossbeam on which the modules are mounted.
Figure 1-11
Proceed in reverse order to install the retainers.
Adjusting retainers:
Caution
!
Do not exert pressure on the module. This means that you should not push
down or force the retainers in any way.
RI 45 PIII, Manual
C79000-G7076-C817-01
Bend the two notched spring clips slightly inwards to release the snap-in
lockings.
Grip the crossbeam and push it about 1 centimeter (half an inch)
backward and then lift it out with the retainers.
Retainer
Module Retainers and Crossbeam
Insert the sliding element at the top and push it down until it covers the
module. Then guide the module into the notch.
Cut off the part of the sliding element that sticks out as described below:
– Scratch a notch in the top of the sliding element on the upper edge of
the retainer using a knife and bend it over to break it off.
– Cut off any leftover part using a sharp side cutter.
System Unit
1-15
Advertisement
Table of Contents
