Table of Contents
Advertisement
Motherboard
Option "Primary /
The system jumps to the following submenu when you select this type of
Secondary"
menu option:
Figure 2-12
The parameters which you can select here are usually saved on the respective
IDE drive, and are read from the drive and entered into the form when you
select the option "Autodetect Hard Disk."
Option "Type"
If you select the option "Type" for a drive which does not exist, an abort is
executed after approximately one minute as a result of a timeout and the
existing entries remain unchanged. It is therefore only meaningful to carry
out an autodetect for interfaces to which drives are connected.
Under certain circumstances it may be necessary to deviate from the
proposed hard disk parameters. In this case, select the corresponding menu
option and then the desired value using the [+] and [-] keys. Enter "none" in
the option "Type" if no drive is connected, or a number from 1 to 39 if a
predefined type of hard disk is to be used.
Select "User" if you wish to define your own type of hard disk; you must
then additionally enter the hard disk-specific parameters in the options
"Cylinders," "Heads," "Sectors/Track," "Write Precomp."
2-38
PhoenixBIOS Setup Utility
Main
Advanced
Security
Primary Master [3249MB]
Type:
[Auto]
Cylinders:
[ 17475]
Heads:
[
Sectors
[
Maximum Capacity
8455MB
[16 Sectors]
Multi-Sector Transfers:
LBA Mode Control:
[Enabled]
[Enabled]
32 Bit I/O:
[FPIO 4 / DMA 2]
Transfer Mode:
[Mode2]
Ultra DMA Mode:
F1
Help
Select Item
+ / -
ESC
Exit
Select Menu
Enter Select
Example: "Primary Master"
Power
Boot Sequence
Version
Item Specific Help
[AUTO] (recommended)
Autotypes installed
IDE-devices
15]
63]
[USER]
Enter parameters of
IDE-devices installed
at this connection
Change Values
F9
Setup Defaults
Sub-Menu
F10
Save and Exit
C79000-G7076-C817-01
Exit
RI 45 PIII, Manual
Advertisement
Table of Contents
