Wizard - Quick Start Via Pdm - Siemens SITRANS F Quick Start Manual

Note
When joining the cables by short branch cables in a multidrop configuration, it is recommended to use EMC shielded
enclosure to ensure proper signal installation.
● This example shows an EMC shielded enclosure for multidrop installation where the connection includes signal and
power. Signal cable screen should be connected according to national requirements.

Wizard - Quick Start via PDM

Wizard - Quick Start via PDM
The graphic Quick Start Wizard provides an easy 5-step procedure that configures the device for a simple application.
Please consult the SIMATIC PDM operating instructions or online help for details on using SIMATIC PDM.
1. If you have not already done so, check that you have the most up-to-date Electronic Device Description (EDD) for your
instrument.
2. Launch SIMATIC Manager and create a new project for FC410. (Application Guides for setting up Modbus devices with
SIMATIC PDM can be downloaded from the product page of our website at: www.siemens.com/FC410).
Access level control
The parameters are protected against changes by access level control. To gain access, select "Access Management" from
the device menu, select "User" and enter the PIN code.
The default user PIN code is "2457".
Quick start
Note
- The Quick Start wizard settings are inter-related and changes apply only after you click on "Apply and Transfer" at the end
of step 5 to save settings offline and transfer them to the device.
- Do not use the Quick Start Wizard to modify individual parameters.
- Click on "Back" to return and revise settings or "Cancel" to exit the Quick Start.
Launch SIMATIC PDM, open the menu "Device – Wizard - Quick Start", and follow steps 1 to 5.
12
SITRANS FC410 flowmeter
A5E33120231-001, 12/2013