Skope TCE1000 User Manual

Skope TCE1000 User Manual

Two door upright fridge

Advertisement

TCE1000
SKOPE Two Door Upright Fridge

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TCE1000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Skope TCE1000

  • Page 1 TCE1000 SKOPE Two Door Upright Fridge...
  • Page 2 For pricing information on an extended warranty visit www.skope.com/warrantyprotection Service & Support We know you will get years of satisfaction from your new SKOPE product when you follow a few simple preventative maintenance guidelines.
  • Page 3: Table Of Contents

    Troubleshooting......... 11 SKOPE TCE1000...
  • Page 4: Installation

    Do not store explosive substances such as aerosol cans with a  flammable propellant in this appliance. Please contact SKOPE Customer Services for advice regarding  disposal of this appliance. CAUTION Never overload the power supply, which could damage the chiller and product.
  • Page 5: Positioning The Cabinet

    SKOPE TCE1000 Positioning the Cabinet Climate Class The chiller is designed to operate within a climate class 4 environment (30°C @ 55% relative humidity). Chiller The location of the chiller may be the single most important decision that will Location extend its life and ensure economical, high performance.
  • Page 6: Shelves

    SKOPE TCE1000 Shelves The chiller is fitted with four layers of wire shelves which may be positioned at different heights to suit various products. Shelf Clips Each wire shelf is held in place with six shelf clips, which engage in the shelf support strips.
  • Page 7: Operation

    SKOPE TCE1000 Operation Automatic Start-Up After the cabinet has been positioned in a suitable place, plug it in and check the following activity. Item Activity An electronic controller runs the chiller and is visible in a Electronic cutout below the sign. The display panel on the electronic Controller controller shows the cabinet internal temperature.
  • Page 8: Loading Product

    SKOPE TCE1000 Loading Product Let the chiller run 30 minutes before loading it with product the first time. When loading the shelves with product: Allow adequate air space around each item to ensure even cooling and  efficient operation of the chiller.
  • Page 9: Electronic Controller

    (see below). SKOPE do not recommend that the setpoint range be changed unless it is absolutely necessary, and then only by small increments at a time. To change the temperature setpoint range 1.
  • Page 10: Servicing

    SKOPE TCE1000 Servicing Cleaning Cabinet Wipe the inside and outside of the cabinet with a damp cloth, taking care to keep moisture away from electrical parts. As with any maintenance, ensure the chiller is unplugged from the power supply before cleaning.
  • Page 11: Lighting

    SKOPE TCE1000 Lighting The cabinet and sign LED lights are all non-serviceable and must not be tampered with in any way. If a light is suspected of being faulty, arrange a service call. Troubleshooting For questions about the electronic controller, see page 9. For problems with the cabinet and refrigeration unit, use the following table.
  • Page 12 NZ: 0800 947 5673 skope@skope.com www.skope.com Trademark Infringement The SKOPE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after their state, condition, get-up or packaging has been altered in any manner •...

Table of Contents