Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Skope ReFlex RF6.UBR.1.SD
Summary of Contents for Skope ReFlex RF6.UBR.1.SD
- Page 1 ReFlex 1-Door Underbench SKOPE Fridge and Freezer Hydrocarbon...
- Page 2 E-mail: skope@skope.com Website: www.skope.com Trademark Infringement The SKOPE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after their state, condition, get-up or packaging has been altered in any manner •...
-
Page 3: Table Of Contents
SKOPE Connect App ........ - Page 4 Defrosting (Freezer Only) ....... . . 41 SKOPE Reflex 1-Door Underbench Fridge and Freezer...
-
Page 5: Servicing Hydrocarbon
Special service requirements are needed as hydrocarbon refrigerants are flammable. Safety hazards The main hydrocarbon safety hazards are: Flammable refrigerant. Venting of hydrocarbon and compressor oil. Asphyxiation. SKOPE does NOT recommend performing hazardous activities on the refrigeration system. Servicing Hydrocarbon Service Manual... -
Page 6: Skope Hc Service Requirements
SKOPE HC Service Policy (available from SKOPE), including the following: Hydrocarbon work – SKOPE Service Policy It is the responsibility of the service technician to follow SKOPE’s Hydrocarbon equipment service policy and by accepting a service work order they agree to the following (where applicable): MUST –... -
Page 7: Specifications
SKOPE Reflex 1-Door Underbench Fridge and Freezer Specifications Models This service manual is applicable to the SKOPE ReFlex 1-Door Underbench models detailed in the table below. Refer to the relevant product specification sheet (available on the SKOPE website: www.skope.com) for specifications. -
Page 8: Electronic Controller
SCS Connect The Wellington Drive Track app for mobile devices transfers data from Track App SKOPE equipment that utilise the SCS Connect controller to a cloud based server. The app works automatically in the background. When the app detects a controller, it connects via Bluetooth to receive data from the controller and send data to the cloud. -
Page 9: Controller Faceplate
( refer to Wellington Drive Technologies documentation for further information. Note: A 9 digit pin code is required to access service mode via the controller buttons. Contact SKOPE to receive your service mode pin code. Electronic Controller Service Manual... - Page 10 SKOPE Reflex 1-Door Underbench Fridge and Freezer There are 5 main service mode categories when accessing and using service mode via the controller faceplate: Parameters Provides access and editing of individual controller parameters. It is not recommended that parameters are changed unless absolutely necessary.
-
Page 11: Scs Connect Field App And Track App
To connect to a cabinet 1. Ensure Bluetooth is enabled and you have internet access on your mobile device. 2. The app shows a list of nearby SKOPE cab- inets. The signal bars indicate how close each cabinet is. 3. Select the cabinet of interest and press ‘CONNECT’. -
Page 12: App Categories
Google Play Store or Apple App Store. 2. Enter your unique Activation Code and press ‘Activate’ (the same code as used for SCS Connect Field app). The activation code is provided by SKOPE Customer Services. 3. Respond to any dialogue boxes that appear and the app should be ready to use. - Page 13 SKOPE Reflex 1-Door Underbench Fridge and Freezer Load parameter file Allows reloading of model default parameter set or changing to new parameter set. See “Replacing the Controller” on page 39 for instructions. Note: Updated parameters are not applied until DISCONNECT has been selected from the menu (after loading new parameter set).
-
Page 14: Faults And Alarms
Refer to the tables below for faults and alarm descriptions and possible causes and actions. The service tech type column refers to the service tech skill level required to complete a task. Refer to the SKOPE HC Service Policy (available from SKOPE) for service tech type details. Faults (alarm indicator lit - no message displayed) - Page 15 SKOPE Reflex 1-Door Underbench Fridge and Freezer Alarms Code Description Service tech Possible root cause type dor Door left open. 1, 2, 3, 4 - door not self closing (torsion fault) - door switch / circuit The door has been open for several minutes.
- Page 16 SKOPE Reflex 1-Door Underbench Fridge and Freezer Code Description Service tech Possible root cause type Controller update failed - App 1, 2, 3, 4 - controller / circuit Controller update could not be completed. Controller hardware failure - App 1, 2, 3, 4 - controller / circuit Controller hardware has failed.
-
Page 17: Notes
SKOPE Reflex 1-Door Underbench Fridge and Freezer Notes Electronic Controller Service Manual... -
Page 18: Wiring
SKOPE Reflex 1-Door Underbench Fridge and Freezer Wiring ReFlex Underbench Fridge (RF6.UBR.1.SD) 1-Door WIRE COLOURS Black Brown Orange Green Blue Grey White GNYE Green-Yellow Based upon IEC 757 Standard Wiring Service Manual... -
Page 19: Reflex 1-Door Underbench Freezer (Rf6.Ubf.1.Sd)
SKOPE Reflex 1-Door Underbench Fridge and Freezer ReFlex Underbench Freezer (RF6.UBF.1.SD) 1-Door WIRE COLOURS Black Brown Orange Green Blue Grey White GNYE Green-Yellow Based upon IEC 757 Standard Wiring Service Manual... -
Page 20: Spare Parts
SKOPE Reflex 1-Door Underbench Fridge and Freezer Spare Parts ReFlex 1-Door Underbench Fridge (RF6.UBR.1.SD) Spare Parts Service Manual... - Page 21 SKOPE Reflex 1-Door Underbench Fridge and Freezer No. Description Part No. Foamed Cabinet Body SKC-0-000-1077-0 Door SKC-0-000-1082-0 Door Gasket SKC-2-110-0433-0 Top Door Bush SKC-2-110-0353-0 Top Hinge SKC-2-006-0493-0 Door Lock Tab SKC-2-006-1076-0 Control Probe SKC-4-030-0006-0 Bottom Wire Shelf SKC-2-120-0193-0 Bottom Hinge...
-
Page 22: Reflex 1-Door Underbench Freezer (Rf6.Ubf.1.Sd)
SKOPE Reflex 1-Door Underbench Fridge and Freezer ReFlex 1-Door Underbench Freezer (RF6.UBF.1.SD) Spare Parts Service Manual... - Page 23 SKOPE Reflex 1-Door Underbench Fridge and Freezer No. Description Part No. Foamed Cabinet Body SKC-0-000-1084-0 Door SKC-0-000-1082-0 Door Gasket SKC-2-110-0433-0 Top Door Bush SKC-2-110-0353-0 Top Hinge SKC-2-006-0493-0 Door Lock Tab SKC-2-006-1076-0 Control Probe SKC-4-030-0006-0 Bottom Wire Shelf SKC-2-120-0193-0 Bottom Hinge...
-
Page 24: Installation
SKOPE Reflex 1-Door Underbench Fridge and Freezer Installation Installation Guidelines When installing this cabinet, ensure the installation guidelines below are considered and met. Ventilation Surface Door Opening Climate Class The installation surface The cabinet must be Ensure all ventilation Allow adequate space... -
Page 25: Cleaning Before First Use
SKOPE Reflex 1-Door Underbench Fridge and Freezer Cleaning Before First Use The cabinet interior and food contact surfaces must be thoroughly cleaned and sanitised before first use. Ensure the cabinet is unplugged from the power supply before cleaning, and use only standard stainless steel cleaners suitable for food preparation areas. -
Page 26: Troubleshooting And Diagnostics
SKOPE Reflex 1-Door Underbench Fridge and Freezer Troubleshooting and Diagnostics Electronic Controller Alarms signal unexpected operational changes in the cabinet or system. When an alarm is activated, use the electronic controller app to assist with fault diagnosis and service as necessary. See page 14 for information. - Page 27 SKOPE Reflex 1-Door Underbench Fridge and Freezer • Moisture build up on door • High humidity. • Check ambient operating or exterior. temperature and ventilation requirements, and reposition cabinet if necessary. • Frequent door opening. • Limit door openings. • Door not closing properly. • Check and clean door gasket.
-
Page 28: Refrigeration System
SKOPE Reflex 1-Door Underbench Fridge and Freezer Refrigeration System The following diagnostic test is useful for workshop diagnosis of a short of gas situation. Perform the test before opening the refrigeration system. It is beneficial to have a correctly operating unit running beside the unit being serviced to compare behaviour. - Page 29 SKOPE Reflex 1-Door Underbench Fridge and Freezer 6. Generally, a system with the correct refrigerant charge will frost back to the compressor. If the frost does not go back to the point noted in table, there may be a capillary blockage or compressor fault. The point where the frost stops is affected by the ambient temperature.
-
Page 30: Replacement Procedures
SKOPE Reflex 1-Door Underbench Fridge and Freezer Replacement Procedures Doors Alignment If a door is out of alignment, realign it by loosening the bottom hinge bracket Adjustment fixing screws, move the door as required, and re-tighten the hinge bracket screws. -
Page 31: Door Hinges
SKOPE Reflex 1-Door Underbench Fridge and Freezer Door Hinges Each door is fitted with top and bottom hinges, and an additional self-closing mechanism which allows the door to self-close. The hinges and self-closing mechanism are replaceable. The top hinge is concealed behind the top cover. -
Page 32: Hinge Reversal
SKOPE Reflex 1-Door Underbench Fridge and Freezer Hinge Reversal The door opening side can be changed by reversing the door hinge. To reverse the hinge 1. Unplug the cabinet from the power supply. 2. Unscrew the bottom hinge - cabinet (3 × screws), and lower the door off the cabinet. -
Page 33: Cabinet Feet And Rollers
SKOPE Reflex 1-Door Underbench Fridge and Freezer Cabinet Feet and Rollers The cabinet is supplied fitted with 2 × adjustable height front feet and 2 × rear rollers. The adjustable height front feet can be rotated to level the cabinet and are removable for replacement. -
Page 34: Refrigeration System
Do NOT open the refrigeration system. Check all components such as the electronic controller and electrical systems. If a sealed system fault is suspected, the system must not be opened; it must be sent to a SKOPE approved service depot for repair. -
Page 35: Gas Detector
SKOPE Reflex 1-Door Underbench Fridge and Freezer Dedicated hydrocarbon gauges. Intrinsically safe hydrocarbon combustible gas leak detector. Intrinsically safe scales to 1gram accuracy. Well ventilated work area. Gas Detector A gas detector is required and must be used when servicing HC systems. A gas detector is a safety device for Hydrocarbon gas to warn the technician that hazardous flammable gas is present. -
Page 36: Evaporator Assembly
SKOPE Reflex 1-Door Underbench Fridge and Freezer Evaporator Fridge Assembly Fridges are fitted with an evaporator plate which is attached to the back wall inside the cabinet. Fridges are also fitted with an evaporator fan at the top of the evaporator plate. - Page 37 SKOPE Reflex 1-Door Underbench Fridge and Freezer Fridges are also fitted with a condensate tray. Remove the rear grille for cleaning. Condenser coil Condenser fan Condensate tray Compressor (fridge only) Replacement Procedures Service Manual...
-
Page 38: Electronic Controller
SKOPE Reflex 1-Door Underbench Fridge and Freezer Electronic Controller Controller The electronic controller is located on the top cover at the front of the Location cabinet. To access and remove the controller 1. Unplug the cabinet from the power supply. -
Page 39: Replacing The Controller
12. Set up controller and cabinet links as required: Corporate The service tech must link to the controller to the cabinet serial number in the SCS Connect Field app. General Market The owner must set up SKOPE-connect (if in use). Replacement Procedures Service Manual... -
Page 40: Control Probe
SKOPE Reflex 1-Door Underbench Fridge and Freezer Control Probe The control probe is located at the back of the cabinet interior. To replace the control probe 1. Unplug the cabinet from the power supply and gain access to the rear of the electronic controller (see steps 1 and 2, “Controller Location”... -
Page 41: Routine Cleaning
Take care to keep moisture away from electrical parts. The condenser coil is located on the back of the cabinet and must be kept clean. SKOPE strongly recommends the condenser coil is brushed monthly to remove dust. Condenser coil... - Page 42 SKOPE Industries Limited A.B.N. 73 374 418 306 AU: 1800 121 535 NZ: 0800 947 5673 skope@skope.com www.skope.com...
Need help?
Do you have a question about the ReFlex RF6.UBR.1.SD and is the answer not in the manual?
Questions and answers