Download Print this page

BOMBARDIER Ski-Doo 1978 Series Operator's Manual page 7

Advertisement

- LIGHTS
A) Throttle Control Lever
BJ
Brake Control Lever
C)
Ignition / Light Switch
D)
Headlamp Dimmer Switch
E) Emergency Cut-Out Switch
FJ
Decompressor (Elan single cylinder
engine only)
G)
Manual Starter Handle
Located on right side of handlebar.
When compressed, it controls the en-
gine speed and the engagement of the
transmission. When released, engine
speed returns automatically to idle.
Located on the left side of handlebar.
When compressed, the brake is ap-
plied. When released, it automatically
returns to its original position. Braking
effect is proportionate to the pressure
applied on the lever.
OFF
Key operated, 3 position switch. To
start engine, first turn key clockwise to
ON position.
To stop engine, turn key
counter-clockwise to OFF position.
Turning key fully clockwise, with en-
gine running, illuminates both head-
lamp and taillight.
OFF
/L1GHTS
_ON
- START
H) Choke (Elan and Alpine models
only)
I)
Primer
J)
Tachometer
K) Speedometer
U
Tether Cut-Out Switch
M) Gear Shift Lever
Key operated, 4 POSition switch. To
start engine, turn key fully clockwise to
START position and hold. Return key
to ON position immediately engine has
started. To stop engine, turn key coun-
ter clockwise to OFF position. To illu-
minate both headlamp and taillight,
turn key to LIGHTS position.
The dimmer switch, located on left side
of handlebar, allows correct selection
of headlamp beam. To obtain high or
low beam simply depress switch.
A push button switch located on right
side of handlebar. To stop the engine
in an emergency, press button down
into lower position.
Before re-startinq engine always de-
press button into released upper posi-
tion. The driver of this vehicle should
familiarize himself with the function of
this device by using it several times on
first outing. Thereby being mentally
prepared for emergency situations re-
quiring its use.
WARNING: If the button has
been used in an emergency situa-
tion the source of malfunction should
be determined and corrected before
restarting engine.
Two positron (OFF / ON). push-pull
knob. To engage, purl decompressor
knob fully out.
5

Advertisement

loading