Advertisement
+
WARNING: Engine should be
running only when pulley guard is
secured in place.
Routine maintenance is necessary for
all mechanized
products, and
the
snowmobile is no exception. A weekly
vehicle inspection contributes to the
life span of the snowmobile as well as
retain safe and dependable operation.
It is recommended that the steering
system and suspension, be lubricated
monthly or every 40 hours of opera-
tion. If the vehicle is operated in wet
snow or in severe conditions these
items should be lubricated more fre-
quently.
+
W A RNING: Only perform such
procedures as detailed in this
manual. It is recommended that dealer
assistance be periodically obtained on
other components / systems not cov-
ered in this manual. Unless otherwise
specified, engine should be turned OFF
for all lubrication and maintenance
procedures.
For any procedure that may require re-
moval of console, proceed as follows:
1. Unlock latch where console and
dashpanel meet.
2. Push the console downward then
tilt away from engine. To reinstall,
reverse procedure.
12
1. Tilt cab and remove console.
2. Remove driven pulley guard (front)
by
unlocking
it
from
attaching
points.
3. To remove drive pulley guard, pull
out retaining clip (A) and pull on
spring (B) to disengage pin from
bracket.
4. Push pulley guard forward to disen-
gage front attchement (C) from
frame. Lift guard from vehicle.
Detach air duct from engine and pull it
from muffler compartment wail. Un-
lock pulley guard from attaching points
and remove from vehicle.
Advertisement
