Advertisement
1.
Tilt cab, unscrew wing nut
(A)
and
pullout retaining clips
(8
&
C).
2. Disengage guard from rear and mid-
dle brackets then disengage pin
from front bracket. Remove com-
plete assembly.
1.
cab. Pull out retaining clip
(A) and tilt driven pulley guard to-
ward front of vehicle.
2. Pullout retaining clip (8) to disen-
gage pin (C) from bracket.
3. Move pulley guard toward front of
vehicle to disengage front attaching
device from front bracket.
•
WARNING: Never start or run en-
gine without drive belt installed.
Running an unloaded engine is dange-
rous.
1. Tilt cab and remove pulley guard.
On Everest and T'NT models, un-
lock and raise driven pulley support.
2. Open the driven pulley by twisting
and pushing the sliding half. Hold
In
fully open position.
3. Slip slackened belt over the top
edge of the sliding half.
~
13
Advertisement
