Advertisement
4. Slip the belt out from the drive pul-
ley and remove completely from ve-
hicle. To install drive belt, reverse
procedure.
Remove cab and pulley guard. Remove
the two bolts (A) holding disc brake to
the frame. Loosen nut (8) to separate
brake caliper from disc brake bracket.
Pivot the brake bracket assembly half
a turn. Open the driven pulley. Twist
and push the sliding half then hold in
open position; slip slackened belt over
the top edge of the sliding half. Slip
the belt out from the drive pulley and
remove from vehicle by passing it
under the driven pulley and disc brake
assembly. To install drive belt follow
reverse procedure.
Lubricate the suspension bogie wheels
using low temperature grease. Pump
through the grease fitting at center of
14
each wheel until new grease appears at
the joint of inner side of shaft.
On Alpine model, to grease the inner
side bogie wheels, tilt vehicle on its
side and apply pressure on track to
expose grease fittings.
Lubricate the rear axle with low-tem-
perature grease. Pump through the rear
axle fittings.
CAUTION: Always use a low
pressure grease gun when lubri-
cating rear axle.
Using a low pressure grease gun, lubri-
cate the idler wheels with low tem-
perature grease. Pump 3 to 4 times
through the grease fitting located on
each cap of idler wheel. Wipe off
excess.
•
WARNING:
Do not lubricate
throttle and / or brake cable and
housings.
Advertisement
