Advertisement
,@--
I
'<.
".~
Ventilation
~I
~
(,Q)
(0)
Check electrical wiring and compo-
nents,
retighten loose connections.
Check for stripped wires or damaged
insulation.
Thoroughly inspect the vehicle and
tighten loose bolts, nuts and linkage.
O
NOTE: Leave drive belt off pul-
leys for the entire storage period.
_
CAUTION: On olvmpique mod-
... els, to retain the efficiency of the
cooling system, check that the belly
pan ventilation hole is not blocked or
obstructed.
Touch up all metal spots where paint
has been scratched off. Spray all bare
metal parts of vehicle with metal pro-
tector. Wax the cab for better pro-
tection.
O
NOTE: Apply wax on glossy fin-
ish of cab only. Protect the vehi-
cle with a cover to prevent dust accu-
mulation during storage.
_
CAUTION: If for some reason the
. . snowmobile has to be stored out-
side it is necessary to cover it with an
opaque tarpaulin. This caution will pre-
vent the sun rays affecting the plastic
components and the vehicle finish.
Slowly crank engine several times
using manual starter, If applicable, re-
peat above steps for other cylinder.
Install spark plugs.
_
CAUTION: To prevent ignition
. . system damage, make sure that
the cut-out button is in the lower posi-
tion.
Remove battery from vehicle and dean
outside surface of battery with solution
of baking soda and water. Remove all
deposits from posts then rinse with
clear tap water.
_
CAUTION: Do not allow cleaning
... solution to enter battery interior
since it will destroy the electrolyte.
Check electrolyte leve!. Refill if neces-
sary with distilled water. Fully charge
battery. (A stored battery should be re-
charged at least every 40 days).
WARNING: Gases given off by a
battery being charged are highly
explosive. Always charge in a well
ventilated area. Keep battery away
from cigarettes or open flames. Avoid
skin contact with electrolyte.
Coat battery terminals with petroleum
jelly and store unit in a cool, dry place,
IMPORTANT: Lack of preventive main-
tenance could void battery warranty,
Clean the vehicle thoroughly, removing
all dirt and grease accumulation,
-
CAUTION: Plastic alloy compo-
. . nents such as fuel tank, wind-
shield, etc., can be cleaned using mild
detergents or isopropyl alcohol. Do not
use strong soaps, degreasing solvents,
abrasive cleaners, paint thinners, etc.
lnspect cab and repair damage. Repair
kits are available at your authorized
dealer. Clean frame. For aluminum
frame use only "Aluminum cleaner"
and follow instructions on container.
29
Advertisement
