Advertisement
Intensity zone
of high beam
With the suspension correctly ad-
justed, the rider seated on the vehicle
and the high beam ON (engine must be
running on manual
start
models),
check that the center of high intensity
zone of high beam is 50 mm (2") below
horizontal line of headlamp height.
To adjust, on vehicle so equipped re-
move headlamp chrome ring, turn
upper or lower adjusting screws to ob-
tain desired beam position.
tilt cab. Unplug
connector
headlamp.
Remove
rubber boot and unfasten bulb retainer
clips. Detach bulb and replace. If tail-
light bulb is burnt, expose bulb by re-
moving red plastic lens. To remove,
unscrew the two (2) Phillips head
screws. Verify all lights after replace-
ment.
Center
tine
of
intensity zone
Headlamp horizontal line
Iheight of headlamp)
t
r;:::o=.:::~~
' - -------r-
hicle and tighten loose bolts, nuts and
linkage. Inspect skis and ski runners
for wear.
Check that the
pan ventilation ho-
le is not blocked or obstructed. Block-
age of the system will create engine
overheating.
O
NOTE: The condition of the ven-
tilation must be checked more
often if the vehicle is used on rough
trails.
The angle
the headlamp beam has
been pre-adjusted prior to delivery.
Should you wish re-adjustment, place
vehicle on a flat surface 7.6 m (25')
from a wall or screen.
TOPVIEW
SIDE ViEW
~
Ground
26
Advertisement
