Storage Precautions; Removal From Storage - Honda F220 Owner's Manual

STORAGE

STORAGE PRECAUTIONS

If your tiller will be stored with gasoline in the fuel tank and carburetor, it is
important to reduce the hazard of gasoline vapor ignition. Select a well
ventilated storage area away from any appliance that operates with a flame,
such as a furnace, water heater, or clothes dryer. Also avoid any area with a
spark-producing electric motor, or where power tools are operated.
If possible, avoid storage areas with high humidity, because that promotes
rust and corrosion.
Unless all fuel has been drained from the fuel tank, leave the fuel valve in the
OFF position to reduce the possibility of fuel leakage.
Place the tiller on a level surface. Tilting can cause fuel or oil leakage.
With the engine and exhaust system cool, cover the tiller to keep out dust.
A hot engine and exhaust system can ignite or melt some materials. Do not
use sheet plastic as a dust cover. A nonporous cover will trap moisture
around the tiller, promoting rust and corrosion.

REMOVAL FROM STORAGE

Check your tiller as described in the BEFORE OPERATlON chapter of this
manual (see page 13).
If the fuel was drained during storage preparation, fill the tank with fresh
gasoline. If you keep a container of gasoline for refueling, be sure that it
contains only fresh gasoline. Gasoline oxidizes and deteriorates over time,
causing hard starting.
If the cylinder was coated with oil during storage preparation, the engine may
smoke briefly at start-up. This is normal.
44