Table of Contents
Advertisement
V. REMOVE GREASE FROM THE SAW TOP
The protective coating on the saw table top and extension wings prevents
rust from forming during shipping and storage. Remove it by rubbing with a
rag dipped in kerosene, mineral spirits or paint thinner. (Dispose of poten-
tially flammable solvent-soaked rags according to manufacturer's safety
recommendations.) A putty knife, held flat to avoid scratching the surface,
may also be used to scrape off the coating followed by clean-up with
solvent. Avoid rubbing the saw's painted surfaces, as many solvent-based
products will remove paint.
Suggestion: With a screw driver, push a solvent-saturated rag into the T-slots,
gauge will slide freely.
VI. ASSEMBLE THE STEEL EXTENSION WINGS
Attach extension wings using the 6 hex head screws and
lock washers, right. Make screws only finger tight at first.
Use a straightedge to ensure that wing is level with table
from front to back. Gently tap wing up or down, then
tighten screws with the supplied combination wrench,
leaving the center screw last to be tightened.
Be sure that extension wings are flush with front edge of
table.
VII. ASSEMBLE THE FRONT FENCE RAIL / GUIDE TUBE
Using 6 square head bolts (2 short bolts & 4 long). With their corresponding flat washers & hex. nuts,
to the front of the table as follows:
1.
1 short bolt into each steel extension & 4 long bolts into the main table- as shown below,
2.
Do not tighten down the nuts, leave the square heads of the bolts protruding from the table,
3.
Slide the upper slot of the rail onto the square head bolts,
rail is aligned with the edge of the extension wing,
4.
Tighten down the nuts to firmly secure the rail to the table.
6
, to remove the grease so the miter
, until all 6 bolts are in the slot and the left end of the
.
level here
flush here
, install the bolts
.
.
Hide quick links:
Advertisement
Table of Contents
