Siemens 6GK1 901-1GB01 System Manual page 94

Installing network components in cabinets
3.3 Guidelines for setting up networked automation systems in buildings
Figure 3-6
● When removing the sheath of the cable, make sure that the braid shield of the cables is
● To allow good contact between grounding elements, tin-plated or galvanically stabilized
● Unless specifically intended for this purpose, shield clamps and contacts should not be
94
Securing shielded cables with cable clamps and ties (schematic representation)
not damaged.
surfaces are ideal. With galvanized surfaces, the necessary contact should be achieved
using suitable screws. Painted surfaces should be avoided at the contact points.
used for strain relief. The contact with the shielding bar could be impaired or be broken
altogether.
Passive network components
System Manual, 02/2013, C79000-G8976-C282-01