Fitting The Ie Fc Tp Cable With An Ie Fc M12 Plug Pro - Siemens 6GK1 901-1GB01 System Manual

Instructions for fitting connectors, attachments and devices
2.3 Electrical networks
2.3.6

Fitting the IE FC TP cable with an IE FC M12 plug PRO

Introduction
The individual steps required to assemble an IE FC TP cable and an IE FC M12 plug PRO
are explained below.
Note the information in the assembly instructions of the plug.
Procedure
a front part of connector
b connector housing
c catch
1. Press the catch (c) in the direction
of the arrow.
2. While holding the catch open,
unscrew the connector housing (b)
from the front part of the connector
(a).
24
3. Fit the connector housing (b) over
the cable.
4. Strip the cable as shown in the
drawing using a suitable stripping
tool with the required cutting depth
or using the IE stripping tool*.
* The stripping tool is not suitable for
cables other than FC cables.
Passive network components
System Manual, 02/2013, C79000-G8976-C282-01