Parameter Level 1 - Viessmann Vitodens 100 Series Installation And Service Instructions Manual

Main parameter level
Standby mode
Symbols
Flashing constant

Parameter level 1

Calling up parameter level 1:
1. Hold down MODE and
neously for approx. 5 s.
■ "SEt" and
flash.
■ "PL:1" is shown on the additional
display.
■
is shown in the upper display
area
Emissions test mode
Parameter Possible change
"P01" "OFF" Test mode switch-
"On"
With test mode switched
on, use
tween upper and lower
heating output.
Filling and venting function
Parameter Possible change
"P02" "OFF" Function switched
"On"
(cont.)
Main display
"SEt"
simulta-
ed off
Test mode switch-
ed on
/ to change be-
off
Function switched
on
Additional display
2. Press MODE.
■ "P01" is shown on the main dis-
play.
■
is shown and does not flash.
3. Use / to select the parameter.
4. OK to confirm
Main display
With test mode
switched on:
■ Temperature
in °C
Main display
With test mode
switched on:
■ "Air"
Parameter
Additional display
With test mode
switched on:
"LO" For lower
heating out-
put
"HI" For upper
heating out-
put
Additional display
With test mode
switched on:
■ Remaining time
in min
57