Internal Switches Setting; If-633 Board - Sony CA-950 Installation And Maintenance Manual

1-5. Internal Switches Setting

1-5-1. IF-633 board

Ref. No. Switch name
S1-1 to 4 TEST OUT SELECT
S200-1 _
S200-2 RET/SDI SEL
S201-1, 2,4 _
*
S201-3 SETUP
* : Only used for CA-950, not for CA-950P.
CA-950/950P IMM
4 3 2
S1
S201
IF-633 board (A side)
Description
Refer to the operation manual.
Factory use
ON: With return video selector such as CAC-6 connected to the
RET CONT connector, switching this switch ON can select the
SERIAL OUT signal.
To switch the SERIAL OUT output, use the control button of the
return video selector.
The setup menu for CCU determines the selection of signals.
n
With this switch set to ON, the return video selector functions only
for selecting the SERIAL OUT signal, and it cannot select the return
signal output to VF or TEST OUT of this unit.
To select the return signal output to VF or TEST OUT of this
unit, use the return video selection switch on the rear panel of this
unit, or on the camera handle, or the side of the camera.
OFF: Normal mode.
Factory use
Sets ON or OFF the setup function of the return video signal to be
output to VF or TEST OUT.
ON: Setup of 7.5 IRE is available.
OFF: Setup is unavailable.
1
A
B
CN1
C
S200
D
1-5. Internal Switches Setting
Factory setting
S1-1: OFF
S1-2 to 4: ON
OFF
OFF
OFF
OFF
1-11 (E)