Low-Cut Filter Setting (Lcf); Power Setting (+48V); Resetting Accumulated Transmitter Use Time (Time); Internal Signal Setting (Internal Sg) - Sony DWR-R01D Operating Instructions Manual

Changing the Settings on
the Transmitter
For details on menu operation, see "Basic Menu
Operations" on page 28.
You can change the settings on the transmitter that is
paired with this receiver using the GP/CH indication (see
page 29) of the RECEIVER menu or TRANSMITTER
menu (see page 30).
Before changing the settings, be sure to set pairing
configurations in the RF REMOTE menu and enable the
wireless remote control function by setting RF REMOTE
to ON.
The following shows the US model display.
Group/channel Setting
Only this setting is set through the GP/CH indication of the
RECEIVER menu.
For details, see "Selecting the Group/Channel" on
page 25.
Transmitter Name Setting
Sets the name of the transmitter.
Power-saving Setting
To conserve power, this setting allows you to change the
transmitter to sleep mode using the wireless remote control
function.
Note
When the setting of the transmitter is changed to sleep
mode, the signal for audio transmission is stopped and the
metadata is also no longer transmitted. For this reason,
36

Changing the Settings on the Transmitter

Transmitter
Receiver
(GP/CH)
(NAME)
(POWER SAVE)
"NO DATA" appears for all items in the TRANSMITTER
menu, except for "SLEEP" in the POWER SAVE
indication.
Transmission Power Setting
You can change the transmission power of the transmitter.
Audio Input Level Setting
Allows you to change the transmitter's audio input level
setting.
Note
This function may not be supported by some transmitters.
Attenuator Setting
Change the attenuator value when the audio input level
setting of the transmitter is set to MIC.
Note
The attenuator values that can be selected depend on the
transmitter function.
Low-cut Filter Setting
The low-cut filter setting of the transmitter can be changed.
Note
The frequency selection depends on the transmitter
function.
+48 V Power Setting
The +48 V power on the transmitter can be turned on or off.
Note
This function may not be supported depending on the
transmitter.
Resetting Accumulated Transmitter
Use Time
(TIME)
The accumulated use time of the transmitter can be reset.
Internal Signal Setting
Specifies whether to generate the transmitter's internal
signal.
POWER Switch Lock Setting
LOCK)
Specifies whether to lock the transmitter's POWER switch.
(RF POWER)
(INPUT LEVEL)
(ATT)
(LCF)
(+48V)
(INTERNAL SG)
(PWR SW