Table of Contents
Advertisement
NEW EXCALIBUR
•
Press the switch "ON" (I) of the equipment and turn a little
the pressure control knob clockwise (G3), so as the machine
works at the idle speed.
•
Make sure the product recycles from the return tube (G4).
www.larius.eu
16
Close the recirculating-safety valve (G2) (turn clockwise till
•
the valve has released).
G3
•
Now the machine carries on sucking the product till the
flexible hose is full, up to the gun.
Then it will stop automatically.
•
Adjust the work pressure with the knob (G3).
sprAY ADJUsTMeNT
•
Slowly turn clockwise the pressure control knob to reach
the pressure value in order to ensure a good atomization
of the product.
•
An irregular and marked spray on the sides indicates a low
working pressure. On the contrary, a too high pressure
causes a high fog ("overspray") and waste of product.
•
In order to avoid overthickness of paint, let the gun advance
sideways (right-left) when spraying.
•
Always paint with regular parallel bands coats.
•
Keep a safety and constant distance between the gun
and the support to be painted and also keep yourselves
perpendicular to it.
NeVer point the spray gun at yourselves or at
other people.
The contact with the casting can cause serious
injuries.
In case of injuries caused by the gun casting, seek
G4
immediate medical advice specifying the type of
the product injected.
recirculating-safety valve: when working at the
maximum pressure available, releasing the gun
trigger sudden increases of pressure can occur.
In this case, the recirculating-safety valve opens
automatically eliminating part of the product from
the recirculating tube.
Then it closes so as to go back to the first working
conditions.
G2
Ed. 015 - 02/2019
Advertisement
Table of Contents
