Programming Limitations At Control And Indicating Panels; Table 3: Control And Indicating Panel Limitations - Siemens SIGMASYS C Manual

A 38-character text can be entered for every object, every area, every detector zone, every
output of the type AT/ST/EV/AL and every detector.
The detector group text is displayed if no detector text is entered.
The detector group text should preferably be programmed in order to save data points.
Additional requirements for number assignment must be observed in the case of D100 con-
nection
4.1.2

Programming limitations at control and indicating panels

A maximum of 8 objects can be programmed for each control and indicating panel (255 ob-
jects per system).
Objects cannot be centrally programmed for multiple control and indicating panels.
The object numbers must not contain leading zeros.
Up to 89 areas can be programmed per object (up to Version 2.5: only 32 areas).
200 detector zones can be programmed per area.
With control and indicating panels with a software version lower than V3.1, a maximum of 256
outputs per MPC module
or SIGMASYS C control and indicating panel can be configured.
20 commands per operating input are possible (maximum 200 commands distributed over
100 inputs).
With regard to operating panel function keys, a maximum of 20 commands can be assigned
to one key.
A maximum of 60 commands can be configured per operating panel.
The number of individually identifiable event locations, detector zones and zones must not
exceed 1750 per SIGMASYS control and indicating panel.
A maximum of 2500 datapoints can be programmed per SIGMASYS control and indicating
panel. This includes the sum of individually identifiable event locations, detector zones, areas,
outputs and non-coded text.
SIGMASYS control and indicating panel
limitations
2500 datapoints
Subset limitations
1750
1700
1512
1512
1512

Table 3: Control and indicating panel limitations

Multifunctional Danger Control and Indicating Panels SIGMASYS C and M (M-Modules)
Best.Nr. A24205-A337-B970 – Edition 12 (03/07)
see section "D100 Interfaces (Version 3.0 and later)" on page 28>.
4 Project planning for control and indicating panels
Includes total of:
Event locations, detector zones, zones, outputs and non-coded
text
Event locations, detector zones, zones
Individually identifiable detectors
Detector zones
Non-coded text (38 characters)
Outputs (can be activated system-wide)
11 / 128